不同边沿高度油池火燃烧行为的实验和数值模拟研究

采用实验和FDS数值模拟相结合的方法,探讨了边沿高度对油池火燃烧特性的影响。在实验部分,研究了燃烧速率和表观火焰高度随边沿高度的变化趋势,并分别分析了各个阶段的热反馈机制。在实验获得不同尺度、边沿高度正庚烷油池火燃烧速率的前提下,建立相应尺度的不同边沿高度油池火的Fire Dynamics Simulator(FDS)计算模型以针对火焰高度进行了数值模拟研究,分析了实际火焰高度、火焰下探高度随边沿高度的变化趋势,并提出了相关的无量纲拟合式。     

Influence of floc dynamic protection layer on alleviating ultrafiltration membrane fouling induced by humic substances

Cake layer formation is inevitable over time for ultrafiltration (UF) membrane-based drinking water treatment. Although the cake layer is always considered to cause membrane fouling, it can also act as a “dynamic protection layer”, as it further adsorbs pollutants and dramatically reduces their chance of getting to the membrane surface. Here, the UF membrane fouling performance was investigated with pre-deposited loose flocs in the presence of humic acid (HA). The results showed that the floc dynamic protection layer played an important role in removing HA. The higher the solution pH, the more negative the floc charge, resulting in lower HA removal efficiency due to the electrostatic repulsion and large pore size of the floc layer. With decreasing solution pH, a positively charged floc dynamic protection layer was formed, and more HA molecules were adsorbed. The potential reasons were ascribed to the smaller floc size, greater positive charge, and higher roughness of the floc layer. However, similar membrane fouling performance was also observed for the negative and positive floc dynamic protection layers due to their strong looseness characteristics. In addition, the molecular weight (MW) distribution of HA also played an important role in UF membrane fouling behavior. For the small MW HA molecules, the chance of forming a loose cake layer was high with a negatively charged floc dynamic protection layer, while for the large MW HA molecules it was high with a positively charged floc dynamic protection layer. As a result, slight UF membrane fouling was induced.     

非饱和带强化反应层脱氮的试验研究

自然堆肥过程中,畜禽养殖产生的粪污渗滤液入渗土壤非饱和带.高浓度有机氮在微生物作用下经由复杂的地球化学过程转化为各种含氮物质,其中硝酸盐迁移能力较强,在降雨条件下入渗地下水,造成区域性地下水硝酸盐污染.在非饱和带中构建由木屑和壤土组成的强化反应层,通过间歇性的原位淋溶脱氮试验,系统地研究了非饱和带含水量及COD、硝态氮、亚硝态氮和氨氮的浓度变化规律,评价了强化反应层的脱氮能力.研究结果表明:①反应层中木屑材料的强吸水特性使得灌水后短时间内反应层含水量大幅提升,形成有利于反硝化进行的厌氧环境.木屑通过水解作用释放大量溶解性有机碳,供给反硝化微生物进行脱氮.②在入渗硝态氮浓度为170.00 mg·L~(-1)条件下,反应层对硝态氮去除率最高可达97.63%.反应层脱氮量随处理水量增加而提升,当上层为砂土时脱氮量最高,可达24.61 g·m~(-3).③反应层中的NO~-_3-N发生了完全反硝化,出水中NO~-_2-N浓度低于0.5 mg·L~(-1),几乎不发生积累.同时,反应层中发生的DNRA过程使氨氮浓度小幅升高.强化脱氮反应层可阻控硝酸盐污染地下水.     

颗粒物分界层Mie散射激光雷达识别的sigmoid算法

基于成都市2013年6月~2015年5月期间由Mie散射激光雷达探测的大气消光系数廓线资料,发现混合层以上在颗粒物消光和分子消光之间一致存在一个S型的过渡区,利用sigmoid函数对此分布形态进行模拟,通过计算该函数上下曲率最大点所在的高度,据此提出了颗粒物分界层Mie散射激光雷达识别的sigmoid算法.针对该算法模拟效果的分析表明,颗粒物分界层过渡区附近大气消光系数理论廓线和实测廓线保持了高度的相关性,二者在春夏秋冬四季的相关系数（R）分别为0.9971±0.0052、0.9935±0.0167、0.9979±0.0038和0.9990±0.0021（均通过α=0.05的显著性检验）.基于sigmoid算法计算的颗粒物分界层过渡区与成都市温江站探空资料得到的逆温层之间存在很好的对应关系.     

7B04铝合金和30CrMnSiA钢短期腐蚀的电化学行为研究

目的研究7B04铝合金和30CrMnSiA合金钢试样的电化学性能。方法采用电化学实验、扫描电子显微镜(SEM)、腐蚀坑深度测试分别对7B04铝合金和30CrMnSiA合金钢试样在是否经过天然海水浸泡的情况下进行测试分析,得到微观腐蚀形貌和腐蚀坑深度以及试样表面不带锈和带锈时的电化学性能。结果随着Na Cl浓度增大,7B04铝合金和30CrMnSiA钢的自腐蚀电流变大,两者之间存在明显的电位差,接触后会发生电偶腐蚀。电偶电流与阴阳极面积比和Na Cl浓度有关,阴阳极面积比增大或Na Cl浓度升高均会导致电偶效应增强。经过海水短期浸泡后,7B04铝合金表面的锈层不仅没有起到抑制腐蚀的作用,反而使自腐蚀加重,但电偶效应确实有所减弱。结论沿海设备在使用过程中应竭力避免铝合金在锈层下工作。     

WK－1A型二氧化硫自动测定仪测定烟气中SO_2的方法研究

本文研究了仪器电导法测定烟气中ＳＯ２的监测方法，并与碘量法进行了比较，提出了吸收液测定的影响及吸收液的配制方法。本方法简单快速，能够满足烟气中ＳＯ２监测工作的要求。     

烟尘测试中测孔位置和测点的合理布置

根据作者长期在监测第一线的实践经验及在烟尘采样中所遇到的一些具体问题,着重提出了诸多不规则烟道的烟尘采样方法及注意事项,既有理论依据,可操作性也强。     

采样高度和降雪对大气污染物监测结果的影响

大气中SO_2、NO_x、TSP和CO平行采样监测结果的统计分析表明,地面与楼顶采样的差异不显著,其浓度变化有随高度呈规律性的变化趋向,降雪具有明显的洗脱清除作用。     

Application of CFD Methods for Modelling in Air Pollution Problems: Possibilities and Gaps

Different urban air pollution problems deal with complex structure of air flows and turbulence. For such problems the Computer Fluid Dynamics (CFD) methods become widely used. However, this approach despite a number of advantages has some problems. Experience of use of CFD tools for development of models and suggestions of their applications for a local scale air pollution over a complex terrain and stable stratification are discussed in this paper, including: Topography and complex geometry: choose of the co-ordinate system and computer grid; Turbulence closure for air pollution modelling: modified k- model for stable stratified ABL; Boundary conditions for vertical profiles of velocity for stable-stratified atmosphere; Effects of the radiation and thermal budget of inclined surfaces to dispersion of pollutants; Artificial sources of air dynamics and circulation.Some examples of CFD applications for air pollution modelling for a flat terrain, mountainous area, mining open cast and indoor ventilation are discussed. Modified k- model for stably-stratified ABL is suggested. Due to the isotropic character of the k- model a combination of it in vertical with the sub-grid turbulence closure in horizontal can be more suitable for ABL. An effective scheme of boundary conditions for velocity profiles, based on the developed similarity theory for stable-stratified ABL, is suggested. Alongside with the common studies of atmospheric dispersion, the CFD methods have also demonstrated a good potential for studying anthropogenic and artificial-ventilation sources of air dynamic and circulation in local-scale processes of air pollution.     

Mechanics Principle and Engineering Application of Split Layer and Bed Separation of Mining Overburden

<正>To control land surface subsidence caused the underground mineral exploitation and the catastrophic phenomena such as serious damage of buildings, waterbodies, cultivated lands, railways, bridges caused by land subsidence, bed separation grouting technology of overburden is put forward. To provide theoretical support for the technology, the characteristics and the mechanics mechanism of mining overburden from layer-split to formation of bed separation are studied. On the basis of elastic sheet board theory, calculation formula of rock sheet deflection is presented, and the mechanics criteria of the separation formation and the calculation formula of bed separation volume are set up. Finally, the applications and technics of bed separation grout technology of mining overburden to control land subsidence in china are introduced.